Comments
Sort by recent activity
In my case, yes I can remove the input assembly parameter (in fact it looks like I only need the /build <project> parameter now). I think I only had it because when I first started using SmartAssembly a few years ago it only supported absolute paths, so I was using relative paths in my post-build event. Out of curiosity, is there a plan to fix this behavior to work like it did in v6? Or is this an intentional change in v7? / comments
In my case, yes I can remove the input assembly parameter (in fact it looks like I only need the /build <project> parameter now). I think I only had it because when I first started using SmartAsse...
Below are the settings I'm using. Perhaps it's an issue with using a custom template? I'm also executing SmartAssembly from my Visual Studio project as a Post-Build Event, and specifying the error report template on the command line (to ensure the correct relative path is used - I think this was an issue from an earlier version of SmartAssembly). [image] And here is the email that I receive. [image] / comments
Below are the settings I'm using. Perhaps it's an issue with using a custom template?I'm also executing SmartAssembly from my Visual Studio project as a Post-Build Event, and specifying the error ...