Hi Guys
Build 351 - Does not show code (still)
I have done another screen cast to clearly demonstrate results of problem. (captured at 1024x768 this time
)
http://www.usher.net.au/redgate/08.06.0 ... 3/t003.htm
Notes to accompany video
- about screen to confirm build
- highlite of approx 1 minute of profiling to get source to show
note: there is nothing expect main thread showing
- highlite earlier section of code to demonstrate code exists and can be found
- reselect 'bad' area, this time turning on 'Insignificant Methods'
note: only very basic functions are being shown, non of the code I want to profile
- I then show the application and do a nonsense search, then do a real search
note: the 'finding' of the job should yield profile results
note: the 'switching' of tabs also fires code each time a tab is shifted
- Profiler window reselected, highlite section we have just executed - still nothing
- brief error whilst camtasia winow pops up in wrong place
- switch to Visual Studio 2008 with project loaded,
- open JobSearchControl form
- show what event is being fired
- trace event through calls until method I am expecting to see in profiler is shown
I hope this is of some use to you.
Random thoughts: the search control is a user defined control, does this matter to the profiler ?
(possible red herring) as I would still expect to see other code called when switching tabs
Thanks,
Build 351 - Does not show code (still)
I have done another screen cast to clearly demonstrate results of problem. (captured at 1024x768 this time
http://www.usher.net.au/redgate/08.06.0 ... 3/t003.htm
Notes to accompany video
- about screen to confirm build
- highlite of approx 1 minute of profiling to get source to show
note: there is nothing expect main thread showing
- highlite earlier section of code to demonstrate code exists and can be found
- reselect 'bad' area, this time turning on 'Insignificant Methods'
note: only very basic functions are being shown, non of the code I want to profile
- I then show the application and do a nonsense search, then do a real search
note: the 'finding' of the job should yield profile results
note: the 'switching' of tabs also fires code each time a tab is shifted
- Profiler window reselected, highlite section we have just executed - still nothing
- brief error whilst camtasia winow pops up in wrong place
- switch to Visual Studio 2008 with project loaded,
- open JobSearchControl form
- show what event is being fired
- trace event through calls until method I am expecting to see in profiler is shown
I hope this is of some use to you.
Random thoughts: the search control is a user defined control, does this matter to the profiler ?
(possible red herring) as I would still expect to see other code called when switching tabs